Skyjack Compact Rough Terrain Series - Page 70

SKYJACK, Page 71
SJRT Compact Series
Engine Powered
3. Open diode (D-08) at base terminal block.
- Check diode. Replace if defective.
4.1-4. Engine Will Not Crank From Platform or Base Controls
1. Loose or broken wire #8 from horn switch (S8) to start switch (S15) (Platform only).
- Check continuity. Replace if defective.
2. Defective start switch (S15) (Platform only).
- Check switch. Replace if defective.
3. Loose or broken wire #32 from start switch (S15) to base start switch (S32) (Platform only).
- Check continuity. Replace if defective.
4. Loose or broken wire #10E from key switch (S10) to base terminal block (TB-1) (Base only).
- Check continuity. Replace if defective.
5. Defective key switch (S10) (Base only).
- Check switch. Replace if defective.
6. Open or defective diode (D10E) (Base only).
- Check diode. Replace if defective.
7. Loose or broken wire #10B from base terminal block (TB-1) to base choke switch (S31)
(Base only).
- Check continuity. Replace if defective.
8. Loose or broken wire #10B from base choke switch (S31) to base start switch (S32) (Base only).
- Check continuity. Replace if defective.
9. Defective base start switch (S32) (Base only).
- Check switch. Replace if defective.
10. Defective relay (32CR2).
- Check relay. Replace if defective.
11. Loose or broken jumper wire #41 on relay (32CR2).
- Check continuity. Replace if defective.
12. Loose or broken wire #02 from relay (32CR2) to base terminal block (TB-1).
- Check continuity. Replace if defective.
13. Ground not gertting through N/C set of contacts on relay (10CR2) to relay (32CR2).
- Check continuity through contacts. Replace if defective.
14. Loose or broken wire #3A from relay (10BC2) to relay (32CR1).
- Check continuity. Replace if defective.
15. Loose or broken wire #32A from relay (32CR1) to engine harness.
- Check continuity. Replace if defective.
16. Loose or broken wire #32 from relay (32CR2) to relay (32CR1).
- Check continuity. Replace if defective.
17. Loose or broken wire #41 from relay (32CR2) to relay (32CR1).
- Check continuity. Replace if defective.
18. Defective relay (32CR1).
- Check relay. Replace if defective.
19. Loose or broken wire #32A from engine harness to starter contactor (32ACR).
- Check continuity. Replace if defective.
20. Defective starter contactor (32ACR).
- Check contactor. Replace if defective.
21. Loose or broken wire #00 from starter contactor (32ACR) to base terminal block (TB-1).
- Check continuity. Replace if defective.
22. Loose or broken wire #103 from main power disconnect (S1) to starter contactor (32ACR).
- Check continuity. Replace if defective.
Go to Discount-Equipment.com to order your parts