216380ACA SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740
32
Section 3 – Familiarization
Optional equipment
IMPORTANT
The access control unit will not operate if these
power connections are not ON in the set time, or if
the operator disconnects them:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The off/platform/base key switch.
IMPORTANT
To start the access control unit, enter the PIN
code or tap the Smart ID card. These power
connections must be in the ON position in the set
time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The off/platform/base key switch.
Function Tests
Do the function tests as specified in Section 4.3.
When you do the function tests, make sure that the
green light on the keypad is ON. This light confirms that
the access control unit is in operation. Do the function
tests for these power connections in the set time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base control
console
▪
The off/platform/base key switch.
To Next Page
Loading...
Need help?
General
