Skyjack SJ3215 User Manual

SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740 216380ACA
37
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-7 Battery tray side
Do the inspection that follows:
1
Pothole protection device
▪
Make sure there are no loose or missing parts.
▪
Make sure there is no visible damage.
▪
Make sure there is no dirt and blockages.
2
Battery tray
▪
Make sure that the battery tray latches
correctly and is in good condition.
3
Batteries
WARNING
Explosion hazard. Keep flames and sparks away.
Do not smoke near the batteries. Batteries release
explosive gas while you charge them. Charge the
batteries in a well-ventilated area. If you do not
obey, there is a risk of death or serious injury.
WARNING
Corrosion hazard. Do not touch battery acid. Wear
the correct PPE. If the battery acid touches you,
immediately flush the area with cold water and get
medical aid.
1. Do an inspection of the battery case for
damage.
2. Make sure all the battery connections are
tight.
3. If applicable, do a check on the battery fluid
levels. If the plates do not have a minimum
13 mm (1/2 inch) of solution above them, add
distilled or demineralized water.
WARNING
Only use original or manufacturer-approved parts
and components for the MEWP. If you do not obey,
there is a risk of death, serious injury, or machine
damage.
4
Battery charger (SJ3220, SJ3226, SJ4726,
SJ4732, and SJ4740 only):
▪
Make sure that the battery charger is correctly
installed, and in good condition.
▪
Make sure there is no visible damage.
Example models SJ3220, SJ3226, SJ4726, SJ4732
3
1
2
4

Skyjack SJ3215 Specifications

General

Brand	Skyjack
Model	SJ3215
Category	Lifting Systems
Language	English