216380ACA SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740
78
Section 6 – Procedures
Move the MEWP through a doorway
6.10 Move the MEWP through a
doorway
WARNING
Only do this procedure on level ground. If you do
not obey, there is a risk of death or serious injury.
1. Make sure the height/width of the doorway is
sufficient to let the MEWP drive through.
2. Before you operate the MEWP, do a full
inspection of the site (refer to Section 2.4).
Identify hazards in your work area.
3. Make sure the platform is fully lowered.
4. Follow Section 6.5-1 to disconnect and remove
the platform control console.
5. Fold the guardrails if it is necessary. Refer to
Section 6.9 for the procedure on how to fold the
guardrails.
WARNING
Crush hazard. Make sure that there are no
personnel in the path you will travel. Tell personnel
around the path before you move the MEWP. Use
a second person to monitor the movement of
the MEWP. Make sure that person stays at a safe
distance. If you do not obey, there is a risk of death
or serious injury.
6. Connect the platform control console cable to
the electrical plug at the rear side of the MEWP.
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
10. Use the MEWP ladder to enter the platform.
11. Close the gate.
12. Install the lock-pins on the top rear guardrail.
13. Remove the lower lock-pins from the extension
handrails.
14. Push the extension handrails, and install all the
lock-pins. Refer to Figure 24.
15. Install the platform control console onto the
mounting bracket. Install the lock-pin
1
in the
mounting bracket.
16. Put the cable of the platform control console
into the railing clamp. Install the lock-pin
2
on
the railing clamp.
2
1
17. Put the dual height control console on the top
bracket.
18. Tighten the wing screw from the top bracket of
the dual height control console.
WARNING
Before you operate this MEWP, make sure that
the guardrail system does not have loose or
missing lock-pins. The guardrail system must be
in the vertical position. Lock all pins correctly. An
incorrectly locked guardrail can cause a fall, which
can result in death or serious injury.
To Next Page
Loading...
Need help?
General
