Skyjack SJ3215 User Manual

SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740 216380ACA
79
Move the MEWP through a doorway Section 6 – Procedures
7. Stay behind the MEWP.
8. Make sure the platform control console points
in the same direction as the front of the MEWP.
9. Turn the main power disconnect switch to the
on position.
10. Pull the emergency-stop button on the base
control console.
11. Turn the off/platform/base key switch to the
platform position.
12. Pull the emergency-stop button on the platform
control console.
13. Move the inclined drive/level drive switch
to the inclined drive (low speed/high torque)
position for reduced speed.
14. Move the lift/off/drive switch to the drive
position.
15. Use as low a speed as practical to drive the
MEWP forward through the doorway.
16. Push the emergency-stop button when the
MEWP is safely through the doorway.
17. Turn the main power disconnect switch to the
off position.
18. Disconnect the platform control console from
the rear side of the base, and put it on the
platform.
19. Unfold the guardrails if they were folded. Refer to
Section 6.9-3 or Section 6.9-4 for the procedure
on how to unfold the guardrails.
WARNING
Before you operate this MEWP, make sure that
the guardrail system does not have loose or
missing lock-pins. The guardrail system must be
in the vertical position. Lock all pins correctly. An
incorrectly locked guardrail can cause a fall, which
can result in death or serious injury.
WARNING
Fall hazard. Make sure each lock-pin is correctly
installed with the detent ball of each lock-pin fully
through the hole. Failure to avoid this hazard could
result in death or serious injury.
20. Put the platform control console back onto
the mounting bracket. Install the lock-pin in the
mounting bracket.
21. Put the control cable into the railing clamp and
install the lock-pin.
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
22. Use the MEWP ladder to exit the platform.
23. Connect the platform control console cable to
the electrical connector below the platform.

Skyjack SJ3215 Specifications

General

Brand	Skyjack
Model	SJ3215
Category	Lifting Systems
Language	English