EasyManuals Logo

Skyjack SJ46 AJ User Manual

Skyjack SJ46 AJ
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
213210AAAA SJ46 AJ, SJ51 AJ, SJ63 AJ
16
Section 2 – General Safety Precautions Safety instructions
2.2 Safety instructions
WARNING
DO NOT operate this MEWP without proper
authorization and training. Failure to avoid this
hazard could result in death or serious injury.
WARNING
DO NOT operate this MEWP in enclosed areas
without adequate ventilation for exhaust gas and
fumes. Failure to follow this warning could cause
death or serious injury.
WARNING
Failure to heed the following safety precautions
could result in tip-over, falling, crushing, or other
hazards leading to death or serious injury.
KNOW all national, state/provincial or territorial, and
local rules which apply to your MEWP and worksite.
MAKE SURE all the safety and instructional labels
are correctly attached on the MEWP in the correct
location. Clean or replace labels that you cannot read.
DISCONNECT and lock out main power disconnect
on the left side of the MEWP when leaving the MEWP
unattended to prevent unauthorized use.
DO NOT wear jewelry or loose
clothing that could become
caught or entangled.
DO NOT allow the
entanglement of ropes, cables
or hoses with the MEWP,
adjacent structures or objects.
Prevent falling from the
platform. Always keep a rm
footing on the platform oor
when working thereon. Do not
climb on the toe-board, mid-rail,
or top-rail. Do not use planks,
ladders, or any other devices
on the platform for achieving
additional height or reach.
MAKE SURE all occupants wear personal fall
protection equipment.
DO NOT raise the platform or
operate elevated in windy or
gusty conditions that exceed
the limits specied in
Section 7.7.
DO NOT increase the surface
area of the platform or carry
large surface area items when
exposed to wind. Increasing the
area exposed to the wind will
decrease the MEWP stability.
MAKE SURE the ground condition assessment
considers the subsurface voids such as cellars,
basements, culverts, and pipes.
DO NOT elevate or drive
elevated on a slope. Elevated
driving must be done on a rm,
level surface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skyjack SJ46 AJ and is the answer not in the manual?

Skyjack SJ46 AJ Specifications

General IconGeneral
BrandSkyjack
ModelSJ46 AJ
CategoryLifting Systems
LanguageEnglish

Related product manuals