Skyjack SJ46 AJ - Page 36

213210AAAA SJ46 AJ, SJ51 AJ, SJ63 AJ
36
Section 3 – Familiarization Optional equipment and attachments
FAMILIARIZATION
IMPORTANT
If the set time of the access control unit expires,
enter the PIN code or tap the Smart ID card again.
If there is a failure of the access control activation,
speak to the MEWP owner.
IMPORTANT
The access control unit will not operate if these
power connections are not ON in the set time, or if
the operator disconnects them:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The base/off/platform key switch.
IMPORTANT
To start the access control unit, enter the PIN
code or tap the Smart ID card. These power
connections must be in the ON position in the set
time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base
control console
▪
The base/off/platform key switch.
Function Tests
Do the function tests as specied in Section 4.3.
When you do the function tests, make sure that the
green light on the keypad is ON. This light conrms
that the access control unit is in operation. Do the
function tests for these power connections in the set
time:
▪
The main power disconnect switch
▪
The emergency-stop button on the base control
console
▪
The base/off/platform key switch.