SkyWave IDP-680 - Required Materials; Required Tools; Figure 21 Sample Activation Report

IDP 600 Terminal Series - Hardware Guide
© SkyWave Proprietary 25 T200, Version 02
Figure 21 Sample Activation Report
4.2.4 Required Materials
You require the following materials to install a terminal. These materials do not ship with
the terminal.
 Qty 4 - M4 (8-32) 18-8 stainless steel screws (length depends on mounting
surface thickness)
 Qty 4 - M4 (8-32) nuts with 18-8 stainless steel flat and lock washers
 Waterproof sealing tape
 Waterproof sealing compound such as RTV silicone (bottom connector version
only)
 Qty 1 - Custom cable
6
SkyWave recommends that the Solution Provider supply the end-user with a custom built
cable.
4.2.5 Required Tools
You require the following tools to install a terminal.
 Drill
6
Refer to Section 5 for instructions on making a custom cable.
The Mobile ID is the serial number which appears
on the mobile device and is used to uniquely identify
the device when sending and receiving messages
Access ID and password required
to securely access your messages
over the Internet