17
Using the Display
Test Mode Displays
Displayed when the test voltage is ramping up from
0.0 VAC/VDC to full test voltage.
Displayed when the test voltage or test current has
reached full potential. Dwell is the amount of time
the potential or current is held at the set value.
AC/DC Hipot, IR,
Ground Bond
Displayed when a test sequence has passed. The
green TEST button will illuminate and a short audible
beep tone will be activated.
AC/DC Hipot, IR,
Ground Bond
Displayed if the operator elects to stop a test in
process. This can be accomplished by pressing the
RESET button during the test.
Displayed while the test is in process. If the IR value
exceeds the set limits, the test will fail after the DELAY
time has expired.
To Next Page
Loading...
