52
Appendix F - Service and Maintenance
User Service
To prevent electric shock do not remove the tester cover. There are no user serviceable parts inside. Routine
maintenance or cleaning of internal parts is not necessary. Any external cleaning should be done with a clean
dry or slightly damp cloth. Avoid the use of cleaning agents or chemicals to prevent any foreign liquid from
entering the cabinet through ventilation holes or damaging controls and switches, also some chemicals may
damage plastic parts or lettering. Schematics, when provided, are for reference only. Any replacement cables
and high voltage components should be acquired directly from Slaughter Company, Inc. Refer servicing to a
Slaughter Company, Inc. authorized service center.
SLAUGHTER COMPANY, INC.
28105 N. KEITH DRIVE
LAKE FOREST, IL 60045-4546 U.S.A.
PHONE: 1 (847) 932-3662
1 (800) 504-0055
FAX: 1 (847) 932-3665
E-MAIL : support@hipot.com
www.hipot.com
Service Interval
The tester and its power cord, test leads, and accessories must be returned at least once a year to a Slaughter
Company authorized service center for calibration and inspection of safety related components. Slaughter
Company will not be held liable for injuries suffered if the tester is not returned for its annual safety check and
maintained properly.
User Modifications
Unauthorized user modifications will void your warranty. Slaughter Company will not be responsible for any
injuries sustained due to unauthorized equipment modifications or use of parts not specified by Slaughter
Company. Testers returned to Slaughter Company with unsafe modifications will be returned to their original
operating condition at your expense.
To Next Page
Loading...
