Slaughter 4320 - Page 29

23
Remote Memory Bit Selection
Memory #
BIT 3
BIT 2
BIT 1
01
0
0
1
02
0
1
0
03
0
1
1
04
1
0
0
05
1
0
1
06
1
1
0
Where: 1 = Momentary Contact closure between BIT and COMMON
0 = NO Contact closure between BIT and COMMON
 The memory select bits need to be set simultaneously and remain set for a minimum of 20ms to guarantee
that the correct memory will be selected.
 The memory select bits may be set in sequential manner, provided that the time delay between each bit is
less than 4ms.
 When the desired bit pattern has been established it needs to remain set for a minimum of 20ms to
guarantee that the correct memory will be selected.
ACTIVATING TEST PROGRAM FUNCTIONS THROUGH THE REMOTE CONNECTOR
SELECTS THE MEMORY AND STARTS THE TEST THAT IS PRE-PROGRAMMED INTO
THAT MEMORY.
Do not connect voltage or current to the signal inputs. Applying voltage to the
signal input could result in damage to the control circuitry.
WARNING
CAUTION