EasyManua.ls Logo

SMA SUNNY HOME MANAGER 2.0 - Connecting the Voltage Supply up to 63 A

SMA SUNNY HOME MANAGER 2.0
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 Connection
SMA Solar Technology AG
Operating manualHM-20-BE-en-1924
8.2.2 Connecting the Voltage Supply up to 63A
L1 L2 L3
NL1 L2 L3
L1 L2 L3
L1 L2 L3
N
Ethernet
OUT
IN
NL1 L2 L3
L1
L2
L3
N
NL1 L2 L3
L1
L2
L3
N
NL1 L2 L3
L1
L2
L3
N
N
Household
Disconnect switch
Energy meter of
the electric
utility company
Main breaker
(three-phase)
Utility grid
Inverters
Sunny Home Manager 2.0
as purchased electricity
and feed-in meter
Delta-IT
3 phase TN/TT 1 phase TN/TT
Split Phase
Radio
Neutral conductor
Line conductor
Meter output, load side
Meter input, grid side
L1/L2/L3
N
OUT
IN
Figure 5: The following figure shows a connection example in TN and TT utility grids in the case of installation at the grid-connection point when
using the integrated measuring unit.
Procedure:
1. Disconnect the connection point from voltage sources and make sure it cannot be reconnected.
2. Connect the line conductors depending on the utility grid conditions to the SunnyHomeManager as follows:
- in Three-phase utility grids connect the line conductors L1, L2, L3 and the neutral conductor N to the screw
terminals at the input of the SunnyHomeManager.
- in Single-phase utility grids connect the line conductor L1 and the neutral conductor N to the screw terminals
at the input of the SunnyHomeManager.
- in Delta IT utility grids connect the line conductors L1, L2 and L3 to the screw terminals at the input of the
SunnyHomeManager. In addition, also connect the line conductor L3 to the neutral conductor N.
- in Split phase grids (split-phase system) connect the line conductors L1 and L2 and the neutral conductor N to
the screw terminals at the input of the SunnyHomeManager.
Open each screw terminal using a cross-head screwdriver, insert the conductor into the contact terminal and
tighten the screw (torque: 2.0Nm).
If you do not want to use the SunnyHomeManager - as provided by default - as a bi-directional device, but should
opt for only one of its two functions, the SunnyHomeManager must be connected as follows:

Table of Contents

Other manuals for SMA SUNNY HOME MANAGER 2.0

Related product manuals