SMA SUNNY HOME MANAGER 2.0 - Directly Controlling Loads

12 Load Control
SMA Solar Technology AG
Operating manual 87HM-20-BE-en-19
12.6 Directly Controlling Loads
Requirements:
☐ You must have the user role Installer or PV System Administrator (see Section16.1, page114).
☐ The load must either support the data exchange protocol EEBUS or the data exchange protocol SEMP (see the
manual of the load and technical information at www.SMA-Solar.com).
Procedure:
1. Connect the load to the local network and carry out the manufacturer-specific registration (see manual of the
load). The load must be located in the same local network as the SunnyHomeManager.
2. EEBus devices must each be actively paired with the SunnyHomeManager (see Section11.6.2, page65). This
step is omitted for SEMP devices; they are identified automatically.
☑ The SunnyHomeManager detects the new load in the local network.
☑ The load is displayed on the page Device Overview > Overview of New Devices.
3. Add the load to the the SunnyHomeManager system. In the case of loads with optional energy consumption,
you can also set the priority and the maximum permissible energy costs.
☑ The new load is automatically displayed on the page Load Overview and Planning with the available
information and setting options.
4. Change the load name if necessary.