Troubleshooting/Problem Solving SMA Technologie AG
Page 154 SI5048-11:EE4206 Technical Description
You can interrupt the emergency charge mode, for example, to refill diesel.
In the emergency charge mode, the process values are shown on the display.
Parameters cannot be changed during the charging process.
If the device is restarted, the settings that were saved before the ECM are loaded.
7. Press <ENTER> again and start the emergency charge
mode (ECM).
8. Press <ENTER> to stop the Sunny Island 5048. The
following message appears.
9. Hold <ENTER> pressed down and the remaining time is
shown using bars on the display.
10. The emergency charge mode was interrupted and the
display shows the following message:
To prematurely end the emergency charge mode, you must restart the Sunny
Island 5048 using the "#410.01 InvRs" parameter.
See the instructions for restarting the device and wait five minutes (see also section
9.5 "Reactivating the Device Following Automatic Shutdown" (Page 63).)
To start ECM
press <ENTER>
Hold key to stop
################
Hold key to stop
###########
To start ECM
press <ENTER>
To Next Page
Loading...
