SMA Technologie AG Opening and Closing
Technical Description SI5048-11:EE4206 Page 31
5 Opening and Closing
The housing of the Sunny Island 5048 has a removable cover. Remove this cover only
when installing the device or for required maintenance or repair work.
5.1 Opening the Device
Proceed as follows:
1. Loosen the six Allen screws on the front side of the Sunny
Island 5048 to remove the cover.
2. Remove the six Allen screws.
3. Carefully and evenly pull the housing cover until it comes
free from the housing.
4. Remove the cover and store it in a safe place while
mounting, installing or repairing the device.
The Sunny Island 5048 should only be installed or opened by suitably
qualified personnel (qualified electrician).
Switch off the Sunny Island 5048 and disconnect all voltage sources
(battery, (stand-alone) grid, generator), (see sections 9.2 "Stopping"
(Page 62) and 9.3 "Deactivation" (Page 63)).
Wait five minutes until the capacitors have discharged.
Ensure that the system cannot be accidentally switched on again.
To Next Page
Loading...
