SMA SUNNY ISLAND 8.0H - Parameter Page in Installer and Expert Mode; Selecting Menus and Parameters

6 Electrical Connection SMA Solar Technology AG
34 SI80H-60H-OffGrid-IA-en-11 Installation Manual
12 If present:
Connect the external energy source.
Section 6.10
13 Insert filler-plugs. Section 6.11
14 Install protective devices for the loads. Section 6.12
15
If AC sources are present in the stand-alone grid (e.g. PV inverters):
Install protective devices for the AC sources in the stand-alone grid.
Section 6.13
16 If a generator is present:
Install protective devices for a generator.
Section 6.14
17 If necessary:
Install the communication interface for RS485.
SI-COMSMA-NR mounting
instructions
18 If necessary:
Install the communication interface for multicluster systems.
SI-SYSCAN-NR mounting
instructions
19 Connect the communication. Section 6.15
20 Connect the battery temperature sensor. Section 6.16
21 If present:
Connect the measuring cable of the battery current sensor.
Section 6.17
22 If a generator is present:
Connect the control cable for the generator.
Section 6.19 ...
Section 6.21
23 If present:
Connect GenMan to the generator.
GenMan technical
description
24 If present:
Connect the control cables of the load-shedding contactors.
Section 6.22
25 If present:
Connect the time control for external processes.
Section 6.23
26 If present:
Connect the message device for events and warning messages.
Section 6.24
27 If present:
Connect the control cable for the battery-room fan.
Section 6.25
28 If present:
Connect the control cable for the electrolyte pump for the
battery.
Section 6.26
29 If present:
Connect the control cable for the use of excess energy.
Section 6.27
Procedure See