6 Mounting
SMA Solar Technology AG
Operating manualSTP110-60-BE-en-1626
☐ A solid support surface must be available (e.g., concrete or masonry, free-standing
constructions).
☐ The mounting location must be suitable for the weight and dimensions of the product.
☐ The mounting location must not be exposed to direct solar irradiation. If the product is
exposed to direct solar irradiation, the exterior plastic parts might age prematurely and
overheating might occur. When becoming too hot, the product reduces its power output to
avoid overheating.
☐ For mounting to the profile rails: at least 2 profile rails must be available for mounting.
☐ For mounting to the profile rails: the support surface of the frame to which the profile rails are
attached should be firm and level (e.g. concrete). Non-fulfillment of these criteria may restrict
servicing.
☐ All ambient conditions must be met.
6.3 Permitted and prohibited mounting positions
☐ The product may only be mounted in a permitted position. This will ensure that no moisture can
penetrate the product.
☐ The product should be mounted such that the LED signals can be read off without difficulty.
Figure 3: Dimensions of the center of gravity of the product (dimensions in mm (in))
6.4 Recommended clearances for mounting
☐ Recommended distances to walls, other devices and objects should be maintained.
1000800
400
450
600
450
600
800
Figure 4: Recommended clearances(Dimensions in mm)
To Next Page
Loading...
