10 Operation
SMA Solar Technology AG
Operating manual STP110-60-BE-en-16 57
Requirements:
☐ The user interface is called up (see Section10.1, page55).
Procedure:
1. Click on [Login] in the top right.
2. Enter the password in the field Password. The standard password for the user group
Installer is pw1111.
3. Click on [Login].
10.2.2 Logging into the user interface as a service provider
After a connection to the user interface of the inverter has been established, the login page opens.
Some of the parameters mentioned in this document can only be adjusted after logging in as
Service provider. If you need to change these parameters, log onto the user interface as
described below.
NOTICE
Property damage due to unauthorized access to the system when the
standard password is used
The standard password of the product is publically available. If you use the standard password,
unauthorized access to your system can be gained. Yield losses and system damage can arise
as a result of unauthorized access.
• Replace the standard password with a secure password immediately Changing the
Password.
NOTICE
Property damage due to unauthorized access to adjustable parameters
All adjustable parameters are protected by the passwords of the user groups Installer and
Service provider. Providing the passwords to unauthorized persons can lead to incorrect
parameters being input, resulting in damage to devices and system malfunctions. The user group
User does not require a password and can view current values and device information without
logging in. The user group User cannot change any settings.
• Only give the passwords for the user groups Installer and Service provider to qualified
persons.
To Next Page
Loading...
