Smanos W600 - Page 19

16
Flash once per 3 seconds Low battery indication, user will receive SMS notication
if detector was connected with hub, please change the
batteries immediately
Tamper Switch
The tamper switch (small black lever underneath the back bracket) will trigger an
alarm notication if an unauthorized attempt is made to remove the detector from its
installed location.
Detection Range Pet Immune Function
2m
3m 6m 9 m
2m
3m 6m 9 m
2m
1m
9m
2m
Working Mode
Testing Mode
After self-testing, press the test
button, the detector switches to the
testing mode and detects once every
10 seconds. It triggers an alarm. After
3 minutes, the LED ashes twice, and
the detector switches to the power
saving mode.
Power Saving Mode
The product features power-saving design. If the detector detects human movement
twice in 3 minutes, it will switch to the sleeping state to save power. At this time, the
LED will not ash and no alarm. After no movement within the next 3 minutes, the
detector switches back to the working state automatically.
Note: When the detector goes into sleeping state, the precondition of alarm is that no one moves in 3
minutes in the detection area; otherwise it will remain in the sleeping state. If the detector is in sleeping state,
it is suggested to leave the room and make sure nobody moves in the detection area. The detector will go
back to working state in 3 minutes.