35
Home Zone
Sensors set to Home Zone are only armed when the system is in Arm Mode (Full
Arm). If Home Mode (Partial Arm) is used, these sensors are not armed and will not
activate the alarm on trigger. We recommend setting PIR Motion Detectors (if purchase
separately) to Home Zone because they should be installed inside the house.
24-Hour Zone
Sensors set to 24-Hour Zone will activate the alarm when triggered, regardless of the
alarm status at the time (Armed or Disarmed or Home Mode).
Delay Zone
The working mode of sensors in this zone will be same as Normal Zone Sensors’, but
the hub will alarm after an Entry Delay Time * if this sensor is triggered when system
was Armed or in Home Mode.
* Entry Delay Time: you can set this delay time on App [Settings]- [Delay Settings]- [Entry Delay Time].
SOS Function of Remote Control
Tap on the SOS icon next to the name of the remote control.
This setting enables you to turn ON/OFF the SOS function of every remote control to
avoid false triggering.
Note: If the remotes SOS function is set to off, the hub will not sound when an SOS key
is pressed.
To Next Page
Loading...
