31
Timed Arm/Disarm
The system can be programmed to automatically arm and disarm the hub at
predened times by following the steps below:
(1) Slide the switch to the "ON" position to activate the setting.
(2) Choose any status you want the system to become (Arm/Disarm/Home Arm).
(3) Choose the activate time of the status.
(4) Tap the date that you want this timer repeat.
Delay Settings
Exit Delay Time: Set a time delay and turn on/off reminding tone for you to leave your
property without triggering an alarm.
Entry Delay Time: Set a time delay and turn on/off reminding tone for you to enter
your property without triggering the Delay Zone* Sensor(s).
You can enable Delay Reminding Tone in this page.
*Delay zone: please refer to page 35
To Next Page
Loading...
