Need help?Do you have a question about the SmarAct MCS2 and is the answer not in the manual?
Product compliance with EU directives and applied standards.
General safety information, symbols, intended use, and environmental conditions.
Details on MCS2 main controllers, housing, channels, and interface options.
Information on available I/O module types and their features.
Required module for digitizing sensor data, type depends on sensor and driver.
List of optional accessories required for specific configurations.
Step-by-step instructions for initial setup and connection of the MCS2 controller.
Configuration details for the MCS2's Ethernet interface, including default settings.
Accessing and using the built-in web server for MCS2 configuration and monitoring.
Using the Hand Control Module to configure network interface settings.
Methods for locating an MCS2 controller with an unknown IP address.
Explains the meaning of different LED patterns indicating the MCS2 device state.
Details power and interface connectors on the MCS2 main controller.
Pin assignment for the D-SUB-15 connector on the main controller for sensor modules.
Pin layout for the D-SUB-15 HD connector for external hand control modules.
Describes USB Type B and RJ-45 connectors for PC connectivity and network communication.
Pin assignment for BNC and D-SUB-37 connectors providing auxiliary digital and analog I/O.
Details the pin assignments for the D-SUB-15 connectors on the MCS2 sensor module itself.
Specifies electrical characteristics of the MCS2, including driver output and I/O.
Defines abbreviations used throughout the technical data section.
General| Operating Voltage | 24 V DC |
|---|---|
| Controller Type | Modular Control System |
| Communication Interface | Ethernet |
| Interface | Ethernet |
| Positioning Range | Depends on motor type |
| Supported motors | Piezo motors |
To Next Page