1 MANUFACTURER DECLARATIONS
1.2 Information, Warnings and Safety Instructions
Please read the following information, warnings and safety instructions in this section carefully
before using the product. The symbols and labels in this manual have the following definitions:
Symbol Definition
This symbol identifies conditions or practices that could result in damage to the
equipment or other property, and in extreme cases, possible personal injury or
death.
This symbol identifies conditions or practices that involve potential electric shock
hazard.
1.2.1 Information – Intended Use
The SmarAct MCS2 controllers are designed to drive SmarAct positioners only. Never connect any
other equipment than SmarAct positioners to the MCS2 controller outputs.
SmarAct MCS2 controllers are laboratory equipment designed according to the safety require-
ments for electrical equipment for measurement, control and laboratory use (DIN EN 61010).
The MCS2 controller should be operated under the following environmental conditions:
• Indoor use only
• Altitude up to 2000 m
• Temperature range from 5
◦
C to 40
◦
C
• Maximum relative humidity 80% up to 31
◦
C, decreasing linearly to 50% relative humidity at
40
◦
C
• Degree of pollution: 2
Please use the provided power supply only. This is required to meet all design specifications.
1.2.2 Danger – Hazardous Voltage
The MCS2 controller described in this manual is capable of generating high output currents at high
voltages. They may cause serious or even lethal injury if used improperly. Therefore, the equip-
ment should only be operated by personnel that is adequately trained and educated to prevent
any improper use.
6
MCS2 User Manual
To Next Page
Loading...