1 MANUFACTURER DECLARATIONS
Please note the following general accident prevention rules:
DANGER
• Never touch any part that might be connected to an output with a high voltage.
• Do not connect products from other manufacturers to the output connectors.
• Never use equipment that is damaged in any way.
• The MCS2 controller contains no user serviceable parts. Never open the hous-
ing. Procedures which require to open the housing must only be carried out
by authorized, qualified and trained personnel.
Output connectors with dangerous signals are labeled with the following symbol:
WARNING
The Sensor Modules connected to these output connectors have pins with a high
voltage, too.
1.2.3 Caution – Unpacking
Please be careful when unpacking the MCS2 controller. Inspect the MCS2 controller for signs of
damage and only use equipment that shows no signs of damage. In case of any damage, contact
SmarAct for replacement. Please save all packing materials in case you would like to transport or
ship the product again.
1.2.4 Caution – Installation Instructions
The MCS2 controller must be installed horizontally with 3 cm air circulation area behind the fan.
Insufficient air flow can cause overheating, which can result in a limited functionality of the con-
troller.
If you are using an OEM version of an MCS2 controller, the controller board must be installed in
such a way, that free air convection can be achieved. Insufficient ventilation will cause overheating
and premature failure. Therefore forced air cooling, for example in a rack with a fan, is preferred.
Make sure that no part of the MCS2 OEM controller board other than the required connectors can
be touched after final installation. Please take care to meet all applicable requirements concerning
electrical equipment in your regulatory domain.
7
MCS2 User Manual
To Next Page
Loading...