SmarAct MCS2 - Caution - Connecting Instructions; Caution - Disposal of Old Equipment

1 MANUFACTURER DECLARATIONS
CAUTION
Avoid touching any circuit components, pins or PCB traces, as these components
are ESD-sensitive devices.
Please touch the OEM boards on their edges only during handling and installation. Discharge
any static charge on your body by touching a grounded object prior to the handling of the MCS2
controller board. If not installed, place the MCS2 controller boards only on conductive surfaces,
such as ESD- safe transport containers (envelopes or foam).
Only apply power to the MCS2 OEM controller board if it is installed in the intended housing. Never
apply power to a MCS2 OEM controller board if any other part than the required connectors can
be touched.
1.2.5 Caution – Connecting Instructions
Never use any other connecting cables than the connecting gear that you obtained from SmarAct.
Never use any third party adapters or cables. This can cause failure or malfunction.
NOTICE
When removing the USB or Ethernet cable, all positioners will be stopped imme-
diately as a safety precaution.
1.2.6 Caution – Disposal of Old Equipment
According to the EU directive 2012/19/EU, as of August 13th, 2012, electrical and electronic equip-
ment may not be disposed of with other wastes in the member states of the European Union.
SmarAct respects the manufacturer’s product responsibility and will take care of environmentally
correct disposal of old SmarAct products free of charge.
To dispose of old SmarAct equipment, you can return it to SmarAct to the following address
postage-free:
SmarAct GmbH
Schuette-Lanz-Strasse 9
26135 Oldenburg, Germany
WEEE-Reg.-Nr.: DE 47992153
8
MCS2 User Manual