X
Fit hub cap A such that valve B does not
become trapped.
X
Press the hub cap evenly onto the wheel with
both hands until you hear the hub cap
engage.
X
Check to make sure the hub cap is seated
securely on the wheel.
Vehicle with steel wheels and wheel hub cov-
ers:
X
Fit the wheel hub cover.
Storing wheels
X
Store wheels in a cool, dry and dark place
when not in use.
X
Protect against oil, grease and fuel.
Using the tyre pressure monitor
Useful information
It is the driver's responsibility to set the
tyre pressure to the recommended cold tyre
pressure suitable for the operating situa-
tion.
The tyre pressure monitor issues a warning
when the
pressure drops in one or more of the
tyres.
The tyre pressure monitor works properly
only if sensors are present in all four tyres,
and after the monitor has learned the correct
tyre pressure for the current operating sit-
uation. This occurs automatically in most
situations, but may also be specified after
restarting the tyre pressure monitor. Before
restarting, check the tyres for the recommen-
ded tyre pressure.
The tyre pressure monitor does not provide a
warning in the following cases:
R
Even loss of pressure on multiple tyres
R
Sudden loss of tyre pressure, e.g. due to the
penetration of a foreign body
R
Incorrectly set tyre pressure
The tyre pressure monitor has a yellow warn-
ing lamp in the instrument cluster for indi-
cating a pressure loss or malfunction.
Restarting the tyre pressure monitor
(on-board computer
with a monochrome
display)
X
Set the tyre pressure of all tyres to the rec-
ommended value.
X
On the multifunction lever press the ´
button repeatedly until the ° and h
symbols are displayed in the instrument
cluster display.
X
Press and hold the a button on the mul-
tifunction lever.
The °
and h symbols will flash in the
instrument cluster display for about
5 seconds. The two symbols then light up.
The tyre pressure monitor is restarted.
Restarting the tyre pressure monitor
(on-board computer with colour dis-
play)
X
Set the tyre pressure of all tyres to the rec-
ommended value.
X
Select Settings > Tyre pressure monitor
in the on-board computer.
The Tyre pressure monitor Use cur‐
rent pressures as new reference val‐
ues? message appears in the display.
X
Select Yes and press a to confirm.
The
display shows the Tyre pressure mon‐
itor restarted message.
If the Tyre pressure monitor restarted
message does not appear after
5 seconds,
repeat the tyre pressure monitor restart.
Using the tyre pressure monitor
135
>> Maintenance and care.
Z
To Next Page
Loading...
Need help?
General
