symmetrical dipped-beam setting and in
the W direction for the asymmetrical
dipped-beam setting.
X
Have the dipped-beam headlamp setting
checked at a qualified specialist work-
shop.
Using the interior lighting
Switching the interior lighting on and
off
The interior
lights go on when you unlock the
doors.
The interior lights switch off in the follow-
ing situations:
R
A door is opened and 15 minutes have
passed.
R
All doors are closed, the vehicle has been
locked and 15 seconds have passed.
R
All doors are closed, the vehicle has not
been locked and 4 minutes have passed.
R
The engine has been started.
The interior lighting can be activated when a
door is open. After closing the doors, the
interior lighting goes out.
X
Press switch : to activate or deactivate
the left-hand reading lamp.
X
Move switch ; to the desired position:
R
interior lighting switched on
R
interior lighting controlled automati-
cally
R
interior lighting switched off
X
Press switch = to activate or deactivate
the right-hand reading lamp.
Adjusting the ambient lighting (colour
display)
On-board computer with colour display: the
ambient
lighting
is set in the on-board com-
puter (Y page 88).
Using the windscreen wipers
Switching on the windscreen wipers
Please note
!
Do not operate the windscreen wipers
when the windscreen is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windscreen can
scratch the glass if wiping takes place
when the windscreen is dry.
If it is necessary to switch on the wind-
screen wipers in dry weather conditions,
always operate them using washer fluid.
!
Vehicles with a rain sensor: if the wind-
screen becomes dirty in dry weather con-
ditions, the windscreen wipers may be
activated inadvertently. This could dam-
age the
windscreen wiper blades or scratch
the windscreen.
For this reason, you should always switch
off the windscreen wipers in dry weather.
!
Make sure that the windscreen wipers are
free of ice. Otherwise the wiper motor may
overheat.
Wiper blades are subject to wear and tear.
smart recommends replacing the wiper blades
twice a year. Worn or damaged wiper blades
cause smearing on the windscreen. On vehi-
cles with a rain sensor, malfunctions are then
possible.
70
Using the windscreen wipers
>> Ensuring good visibility.
To Next Page
Loading...
Need help?
General
