Basic information about the device
Incorrect height alignment is one of the most frequent reasons for unsatisfactory scanning
results!
Figure 28: Height alignment with measuring range template
It is not usually necessary to realign each non-articulated model in respect to height.
Since you will usually work with one model system in a laboratory, you can work with a standard
setting already defined in most cases. However, we recommend making sure that the height deviation
is not too great for each model to be scanned.
Mounting:
Fasten the required spacer plates on the base holders. When doing so, the correct screws must be used
to stabilise the setup. Last of all, position the locking plate fitted with a magnet in place. Place the
object holder being used onto this.
To Next Page
Loading...