General saftey information
When setting up, commissioning and operating the scanner, you must observe the following
safety information at all times:
1.
The device may be operated only by adequately trained staff that has knowledge concerning the
proper use of the device as well as the safety information cited here.
2.
The device is intended exclusively for use in dry, enclosed rooms.
3.
The device may be operated only on a stable base (tabletop, bench, etc.) that has a load bearing
capacity which is at least twice the net weight of the scanner as stated in the technical
specifications.
The base must be fixed to a building wall or have a braced support frame that is suitable for
absorbing vibrations occurring during operation of the scanner.
Besides the pure load-bearing capacity, the sturdiness and stability of the base is crucial for safe
operation of the scanner.
4.
The information on transport and storage must be observed when lifting and transporting the
scanner.
5.
Please do not place any objects on the scanner, as there is a risk that these can fall down owing to
the surface structure as well as the resultant vibrations during scanning operation.
6.
The "Activity 885" scanner has been developed and manufactured in accordance with the
applicable safety standards and with the greatest possible care. In spite of this, the risk of an
electric shock, overheating or fire due to technical defects in individual components cannot be
totally excluded.
You should therefore switch the device off when not using it for longer periods and when it is left
unattended. This also benefits the environment, as it means less electrical energy is consumed.
7.
The scanner contains a motion unit comprising four electrically powered axes of rotation that serve
to position the object during scanning. To enable the object to be clamped in a definite position as
well as a faster workflow during scanning, the movement axes are also kept in position electrically
when the flap is open.
7. General saftey information
To Next Page
Loading...