You can determine the colour in which the last manually added image is to be displayed here.
General settings:
Accompany actions with sound
If activated, the computer will emit a signal for every prompt via the installed speaker. However,
this function is not supported by every PC system.
Smoothes the surface of the 3D object in the viewer additionally. This setting does not have any
effect on the 3D measurement.
Brightness of the reflection
You can adapt the reflection of the light on the object in the 3D viewer here.
You can determine the intensity of the reflection on the object in the 3D viewer here.
If you activate the checkbox, you can change the button command assignment on your mouse
for moving and rotating the object in the 3D viewer.
The light intensity of the sensor during the measurement is influenced by this. "Bright" for
white plaster, "Medium" for beige-coloured, and "Dark" for very dark plaster.
If you activate "show errors", a window with the corresponding error message and description
will appear if exceptions occur.
Reference run for tooth isolation
After activating this function, the reference run is started for each isolated tooth. In this
function, the model cannot slip, however, more time is taken between each tooth isolation.
The removal position is started between each tooth isolation.
This position makes it easier to access the model when isolating teeth.
When activated, the control box shows the object as a pixel cloud in the 3D viewer with the
mouse is moved. This optimises the representation speed during moving.
Log information
If activated, every work step of the scanner and software as well as
the joint communication is saved in a special folder.
Initiate removal position
To Next Page
Loading...