A
BOUT
THE
T
IGER
S
WITCH
10/100
1-10
Power Supply Receptacle
The power receptacle is located on the rear panel of the switch.
The standard power receptacle is for the AC power cord.
Figure 1-8. Power Supply Receptacle
Features and Benefits
Connectivity
◆ 24 dual-speed ports for easy Fast Ethernet integration and for
protection of your investment in legacy LAN equipment
◆ Auto-negotiation enables each RJ-45 port to automatically
select the optimum communication mode (half or full duplex)
if this feature is supported by the attached device; otherwise the
port can be configured manually
◆ Independent RJ-45 10BASE-T/100BASE-TX ports with support
for auto MDI/MDI-X
◆ Unshielded (UTP) cable supported on all RJ-45 ports: Category
3, 4 or 5 for 10 Mbps connections and Category 5 for 100 Mbps
connections
◆ IEEE 802.3 Ethernet and 802.3u Fast Ethernet compliance
ensures compatibility with standards-based hubs, network
cards and switches from any vendor
100-240 V
50-60 Hz 2 A
To Next Page
Loading...
