SMC Networks ISE80 - Page 41

-40-
No.PS※※-OMM0003-J
<Operation - With security code input- >
•Locking
1, Press the
button for 5 seconds or longer in measurement mode.
The current setting “UnL” is displayed.
2, Press the
or button to select keys lock “LoC”.
3, Press the
button to store the setting.
•Unlocking
1, Press the
button for 5 seconds or longer in measurement mode.
The current setting “LoC” is displayed.
2, Press the
or button to select keys unlock “UnL”.
3, When the
button is pressed, input of the security code will be requested.
For how to enter the security code, refer to "How to enter the security code" on page 41.
4, If the security code entered is correct, the display will change to “UnL”. Press any of the
, or
buttons to release the key lock and return to measurement mode.
If the security code entered is incorrect, “FAL” will be displayed and the security code must be entered
again. If an incorrect security code is entered three times, “LoC” is displayed and the display will return
to measurement mode.