SMC Networks PF3A801H-L

-57-
No.PF※※-OMY0005
■[F90] Setting of all functions
Each time the SET button is pressed, the function steps in the order shown in the following table.
<Operation>
Display [F90] by pressing UP or DOWN button in function selection mode.
Press the SET button. Move on to the suction signal input check.
Set all functions
Press the UP or DOWN button to select all function settings.
[on] (use) is selected
Setting of functions
※
[F90] Setting of all functions completed Measurement mode
: Setting of each function
Every time the SET button is pressed, the display moves to the next function in "Order of function settings" on page 58.
Set by pressing UP and DOWN button.
For details of how to set each function, refer to the relevant setting of function section in this manual.
[oFF] (not use) is
selected
Press the SET button
to set.
Return to function
selection mode.
Press the
SET button
for 2 seconds
or longer.