SMC Networks PF3A801H-L

-37-
No.PF※※-OMY0005
■[F 1] Setting of OUT1
Set the output mode of OUT1.
●Switch output modes
Select the output mode required from the table below.
Normal output
Reversed output
Hysteresis mode
Window
comparator
mode
Accumulated
output mode
(Increment)
Accumulated
output mode
(Decrement)
Accumulated
pulse output
mode
Error output
mode
Output OFF
mode
: The operation may become unstable if hysteresis mode or window comparator mode are used during fluctuating flow conditions. In
this case, maintain an interval between the set values and start using after confirming stable operation.
: Applicable errors are Er1, 2, 6, 8, 10, 12, 15 and 16.