4-1
C
HAPTER
4
C
ONSOLE
I
NTERFACE
This chapter provides a basic description of the console menus. For a more
detailed description about specific features, please refer to the appropriate
section in Chapter 3, Configuring the Switch.
Log-in Screen
Once a direct connection to the serial port or a Telnet connection is
established, the log-in screen for the onboard configuration program
appears as shown below.
If this is your first time to log into the configuration program, then use the
default “admin” for both the user name and password. The administrator
has read/write access to all configuration parameters and statistics.
You should define a new administrator password, record it and put it in a
safe place. Select Switch Static Configuration
=>
Administration
Configuration
=>
Change Password, and enter a new password for the
administrator. Note that passwords can consist of up to 15 alphanumeric
characters and are not case sensitive.
Tiger Switch 10/100 6709FL2
username:
password:
To Next Page
Loading...
Need help?
General
