U
PGRADING
F
IRMWARE
B-2
5. After the file has been downloaded, the console screen will display
information similar to that shown below.
Change the baud rate back to 9600 bps. When using Windows
HyperTerminal, disconnect , set the baud rate, and reconnect .
6. Then press Enter to open the Log-on screen.
For details on managing the switch, refer to the appropriate chapters in
this manual.
$$$ Download IMAGE ....O.K !!!
$$$ Update firmware .............................................
...................................................................
...................................................................
...................................................................
.............................
$$$ Update firmware ....O.K !!!
$$$ Note: console baudrate of new image is 9600bps..
$$$ Reboot .....
Tiger Switch 10/100 6709FL2
username:
password:
To Next Page
Loading...
