S
WITCH
S
TATIC
C
ONFIGURATION
M
ENU
4-13
Configuring the IP Address
Use the IP Configuration page to configure the switch’s IP parameters.
Field Attributes
• IP Address – IP address of the switch. Valid IP addresses consist of
four numbers, 0 and 255, separated by periods. Anything outside this
format will not be accepted by the configuration program.
• Subnet Mask – Subnet mask of the switch. This mask identifies the
host address bits used for routing to specific subnets.
• Gateway – Gateway used to pass trap messages from the system’s agent
to the management station. Note that the gateway must be defined if the
management station is located in a different IP segment.
Console – Click Switch Static Configuration
=>
Administration
Configuration
=>
IP Configuration. Specify the IP address and other
parameters. Save your changes, and then reboot the switch to enable the
new settings.
Tiger Switch 10/100 6709FL2 : IP Configuration
===========================
IP Address : 192.168.16.1
Subnet Mask : 255.255.255.0
Gateway : 192.168.16.254
actions-> <Edit> <Save> <Quit>
Select the action menu.
Tab=Next Item BackSpace=Previous Item Quit=Previous Menu Enter=Select Item
To Next Page
Loading...
Need help?
General
