C
ONFIGURING
THE
S
WITCH
3-6
Basic System Information
Use the Switch Settings page to display basic information on the switch,
including hardware/firmware version numbers for the main board and
management software.
Field Attributes
• Description – Switch model number.
• MAC Address – The physical layer address for this switch.
• Firmware Version – Version number of runtime code.
• Hardware Version – Hardware version of the main board.
• Default config value version – Default configuration version.
Web – Click Switch Settings
=>
Basic.
Global Switch Settings
Use the Switch Settings, Advanced menu to configure address aging,
packet transmit delay, and broadcast storm control.
Command Usage
• Aging Time – The switch stores the addresses of known devices. This
information is used to route traffic directly between the inbound and
outbound ports. The addresses are learned by monitoring traffic, and
stored in the dynamic address table. You can set the aging time after
which inactive entries are removed.
• Transmit Delay Bound – Sets the maximum queuing delay.
To Next Page
Loading...
Need help?
General
