Smeg CWC620D - 6 Set-Up; Dishwasher Parameter Modification Procedure


‐CW620/630

13

6 SET-UP

6.1 Dishwasherparametermodificationprocedure:
Onlyaccessibleafterfillingiscompleteorwiththehoodopen.

Access“programmingmode”bypressingthe buttonfor
afewsecondswiththeapplianceonwiththehoodopen
andthetankempty(afterthefillingandheatingphases).
ThedisplayshowsUnLo1:58;whenthebeepsounds,
releasethebuttonandpressitagainatonce.Keep
pressingthebuttonagaintoscrollthroughallthe
modifiableparametersinthefollowingorder:


Rinsingtemperature(boilertemperature)




IMPORTANT: 

Wheneverthetypeofdetergentorrinseaidischanged,itisABSOLUTELYESSENTIALtoflushout
theperistalticpumpsbyplacingtheexternalintakepipesinwaterforafewcycles.

Alwaysuseonlyproductsspecificallyrecommendedforuseinadishwasher.

Failureto comply withthis recommendation
leadsto forfeitureof the warrantyentitlementon
theappliance’swatersystem.

The internal pipes of the detergent and rinse aid pumps should be replaced by the After‐Sales
Service every 12 monthsor 15,000 wash cycles and operation of the diaphragm rinse aid pump
shouldbechecked.


Set‐up
Duringfirststart‐up,thefunctions/parameterslistedbelowmustbesetoradjusted: