Smeg CWC620D - Service Setting (for After-Sales Service Only); Starting the Peristaltic Pumps - Rapid Filling of Detergent and Rinse Aid Delivery Circuit


‐CW620/630

21
6.15 Servicesetting(forAfter‐SalesServiceonly)

SeeinformationonSmegtech
6.16 Startingtheperistalticpumps–rapidfillingofdetergentandrinseaid
deliverycircuit.
Performaftertheparametermodificationprocedureexplainedinthepreviouspoint.

With the dishwasher powered up, access “programming
mode”bypressingtheon/off buttonforafewseconds;at
the “beep”, release the button and press it again quickly
within0.5seconds.
The peristaltic pumps continue to operate until the same
buttonispressed again.Therinse aidanddetergent symbol
lights remain on as long as thepumps are on;bear inmind
thatthe rinseaid peristalticpumpfills thecircuitin about 7
minutes,whileforthedetergentitonlytakes2minutes.


