Smeg CWC620D - Autostart Function; Regeneration Frequency Setup (Models with Softener)


‐CW620/630

18
6.7 Autostartfunction
Modifytheparameter(ON/OFF)bypressing .
Setat“on”tostartthecyclewhenthehoodisclosed.
Setat“off”forcyclestartafterconfirmationwiththestartbutton 

6.8 Regenerationfrequencysetup(modelswithsoftener)
 (Defaultvalue:H03;modifytheparametertosuitthemainswaterhardness.
 At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regeneratingsaltwhennecessary.





Modifythe
valueofthe
parameter
bypressing
.
Hardness
(°dHGerman
degrees)
Hardness(°dF
French
degrees)
Setting
level
Regeneration
off
Regenerationoff
H00
8.5 15 H01
11 20 H02
17 30 H03
22.5 40 H04
28 50 H05
Important:
Duringnormaloperation,thedishwasherwillperform
a number of washing cycles while regeneration is in
progress. During this time (5‐6 cycles) the intake
water will notbetreated, but thiswill notaffect the
washingquality.

33.5
60
H06

Withvaluesover60°fanexternalwatertreatmentdevicemustbeusedandtheregenerationfrequency
mustbesetonH00.