‐CW620/630
31
Cleaningthefilterduringtheday
In case of particularly heavy‐duty working conditions, the filter should be cleaned every 30‐40 cycles,
keepingthe machinein operatingconditions;todo this,carry out the“partial tankpump‐out”routine
(program“P0”).
Pressthebutton,andholditdown,until“P0”and
thedurationof1’appearonthedisplay.
Confirmbypressing ;lightL2turnsorange.
Attheendofthepump‐outtheword“End”flasheson
thedisplay.Thedisplayreturnstoshowing“P1”.Clean
thefilter;thedishwasherautomaticallyfillsthetank
whenthehoodisclosed.
Remove the filters (simply lift them out as shown here), taking care
that no large residues fall into the sump underneath. Clean them to
remove residues and rinse with plenty of water, then put them
correctlybackinplace;donotusesharporpointedtools.
Cleanawayanylimescaledepositstopreventexcessivebuild‐ups;
‐ Ifpossible,leavethehoodajarwhennotinuse;
‐ Clean surfaces thoroughly and often with a damp cloth; use
neutral, non‐abrasive detergents which do not use chlorine
compounds,whichcorrodeanddamagestainlesssteel.
Donotusetheproductsmentionedaboveevenwhencleaningthefloorunderneathorinthevicinityof
thedishwasher,
toensurethatfumesordropscannotdamagethesteelsurfaces.
IMPORTANT:Thedishwasher automatically performsprogram “P0” atthe startof the dayifwaterhas
beenleftinthetankandhasdroppedbelowthetemperatureof40°C
To Next Page
Loading...
