Chapter 4 - Preparing the machine for use
26
Translation from the original
4.3 ADJUSTING HEIGHT OF PRODUCT SUPPORT MESH
Adjust the height of the product support mesh 1 by means of the striker plates 2 and 3
according to the height of the pack. For best packaging, the film must be sealed at
approximately half the height of the product.
4.4 ADJUSTING HOOD OPENING
To adjust the extent of hood opening, you must act on the stop 1 sliding it along the specific
guide.
If you must also adjust the opening strength of the hood, turn the screw 2 clockwise to increase
or anti-clockwise to decrease strength.
To Next Page
Loading...
