Smipack T650 - Routine Maintenance; Nature and Frequency of Maintenance Checks and Operation

83 / 284
Use and maintenance manual
T450 - T650E - T650EF - T650 - T650F
ENGLISH
PRECAUTIONS DURING ROUTINE MAINTENANCE.
Before starting any maintenance operation, described in this chapter, unless
otherwise required, switch the machine off, switch the voltage off, acting on the
main switch and pull out the power supply cable from the mains.
5.1 NATURE AND FREQUENCY OF MAINTENANCE CHECKS AND
OPERATION
Before removing possible impurities deposited on the hot parts wait until the
machine has cooled down.
DAILY MAINTENANCE CHART (12 HOURS OF WORKING)
BELT UNIT
CLEAN THE RESIDUES OF PRODUCT WITH COMPRESSED AIR
EXTERNAL
PROTECTIONS UNIT
CLEAN THE TUNNEL'S INLET AND OUTLET CURTAINS WITH A DAMP
CLOTH
GENERAL CLEANING
TURN OFF THE MACHINE VOLTAGE
USE HOT WATER WITHOUT PRESSURE AND MAKE SURE YOU DO
NOT DIRECTLY SPRINKLE ON THE ELECTRIC AND ELECTRONIC
COMPONENTS
CAUTION!: DO NOT LEAVE WATER RESIDUALS ON THE MACHINE
DRY THE MACHINE WITH LOW AIR PRESSURE
USE SOFT CLOTHS TO DRY THE MACHINE IF IT IS STILL WET
MONTHLY MAINTENANCE CHART (240 HOURS OF WORKING)
BELT UNIT
MAKE SURE THERE IS NO BREAKAGE ON THE FIBREGLASS RODS
CHECK THE WEARING STATE OF TEFLON CHAIN GUIDE
CLEAN AND GREASE THE PINION
EXTERNAL
PROTECTIONS UNIT
ESTERNE
MAKE SURE THERE IS NO BREAKAGE ON THE CURTAINS
THERMAL CHAMBER
UNIT
CLEAN THE INSIDE OF THE THERMAL CHAMBER WITH A DRY
CLOTH
MAKE SURE THERE IS NO BLOCKAGE IN THE AIR PASSAGE
MAKE SURE THAT THE RESISTORS ARE WORKING CORRECTLY
HALF-YEAR MAINTENANCE CHART (1500 HOURS OF WORKING)
BELT UNIT
MAKE SURE THAT THE BELT IS WORKING PERFECTLY
CLEAN THE FIBREGLASS RODS AND MAKE SURE THEY ARE INTACT
CLEAN AND GREASE THE SHAFTS
CHANGE THE PINIONS IF THEY ARE WORN
CHANGE THE TEFLON GUIDES IF THEY ARE WORN
CHECK IF THE BEARINGS ARE NOISY AND IF THERE IS ANOMALOUS
HEATING
5. ROUTINE MAINTENANCE