Vega 30 Router User Manual Introduction SNMP MIB Files for the Vega 30 Router D.1
Issue1 Revision 1 Page 257 © 2017 SAM
Appendix D SNMP MIB Files for the Vega 30 Router
D.1 Introduction
A mib file is used to manage devices in a network usually for the Simple Network
Management Protocol (SNMP). Mib files represents the device, in this case a Vega 30
Router, and describes it for SNMP.
SAM mib files can be downloaded from https://s-a-m.com/support/protocols-and-mibs/.
To use the full SNMP features of the Vega 30 Router, two mib files are required:
• Probel-Common
• Vega30Router
The files are listed below.
D.2 MIB Support
The Vega30Router.mib supports the following functionality, based on SNMP V2 format (see
the MIB file for details of values returned):
•Traps:
• Fan Status
• PSU 1, PSU 2
• Destination Protect
• Destination Client Name
• Destination Routed Source
• Get (read only):
• Application version, Application description, Application copyright, Application build date
• FPGA Number (A, B, C & Z), FPGA Firmware Revision (A, B, C & Z)
• Network MAC Address
• Unit Serial Number
• VG10-CSA, VG10-CSB, VG10-CSC, VG10-AR License status
• Fan Status, Fan Speed
• PSU1, PSU2 Status
• Unit Temperature
• Reference Standard
• Input Information
• Output Information
• Line sync offset
• Table of Sources
• Get/Set (Read/Write):
• Audio V-Fade rates for FPGA A, B & C
• Input Standard
• 4K Input selection
• Route Lock
• Line Sync Enable/Disable, Line Sync Line offset, Line Sync Pixel offset
• 4K output selection
• V-Fade Enable/Disable
• Source 8-Character & Source 32-Character names
To Next Page
Loading...
Need help?
General