⚫ It is strictly prohibited to store flammable or explosive substances in the equipment area.
⚫ It is strictly prohibited to place the equipment in an environment of flammable or explosive
gases or fumes, and it is prohibited to carry out any operation in such an environment.
⚫ It is strictly prohibited to place the equipment close to sources of heat or fire, such as
pyrotechnics, candles, heaters or other heat-generating devices; heat applied to the equipment
may cause damage to the equipment or lead to fire.
⚫ Equipment should be stored in a suitable temperature and humidity environment, in a clean,
dry, well-ventilated area, and protected from dust and condensation.
⚫ It is strictly prohibited to install and operate the equipment beyond the range specified in the
technical specifications, otherwise the performance and safety of the equipment will be affected.
⚫ It is strictly prohibited to install, use and operate outdoor equipment and cables (including,
but not limited to, handling equipment, operating equipment and cables, plugging and unplugging
signal interfaces connected to the outdoor area, working at height, outdoor installation, opening doors,
etc.) under severe weather conditions such as thunder, lightning, rain, snow, and gusts of wind of more
than six degrees.
⚫ It is strictly prohibited to install the equipment in an environment with dust, fumes, volatile
gases, corrosive gases, infrared and other radioactive radiation, organic solvents or excessive salt
content.
⚫ It is strictly prohibited to install the equipment in an environment with metallic conductive
dust, conductive magnetic dust.
⚫ Installation environment ground is solid, no rubber soil, weak soil or easy to sink and other
adverse geological, strictly prohibit the selection of low-lying areas or areas prone to waterlogging,
site level should be higher than the highest historical water level in the region.
⚫ If the equipment is installed in a site with heavy vegetation, in addition to routine weeding,
the ground underneath the equipment needs to be hardened, e.g., by laying cement, gravel, etc.
⚫ When installing, operating, or maintaining the unit, clean the top of the unit of any standing
water, ice, snow, or other debris before opening the door to prevent debris from falling into the interior
of the unit.
To Next Page
Loading...