SolarEdge SE6000H User Manual

WARNING!
The RS485-1 port is used only for the EV Charger and Meter connections
where as the RS485-2 is used for creating a bus of connected inverters. For
configuration inforamtion see Creating an RS485 Bus Connection on page 57.
4.
In the RS485-1 port connect the Meter B, A, G wires in parallel (e.g twist the wires)
with the existing EV Charger wires.
You can use any color wire for each of the A, B and G connections, as long as:
The same color wire is used for all A pins the same color for all B pins and the
same color for all G pins
The wire for G is not from the same twisted pair as A or B.
5. Insert the twisted wires into the connector and tighten them with the screws.
6. Connect the connector back to the RS485-1 port.
7. In the meter, ensure the RS485-1 DIPswitch is down. See Figure 35 .
8. In the meter, set the Modbus address 1-3 of the meter according to table Table 1
Appendix C: Connecting the Energy Meter To the Inverter 79
EV Charging Single Phase Inverter Guide MAN-01-00583-1.5

SolarEdge SE6000H Specifications

General

Model	SE6000H
Manufacturer	SolarEdge
AC Output Power	6000 W
Rated AC Power	6000 W
Cooling	Natural Convection
Noise Level	< 25 dBA
Topology	Transformerless
Number of MPP Trackers	1
Warranty	12 years
Max. Input Voltage	480 V
MPPT Voltage Range	380 - 480 V
Operating Temperature Range	-25°C to 60°C
Dimensions	450 x 370 x 174 mm
Weight	23.6 lbs (10.7 kg)
AC Voltage	208/240 V