SolarMax MaxWeb XPN - Page 53

53
en
Optimise plant capacity Select “Activated” to optimise the plant output. The plant output will
be optimised on the basis of the internal consumption and/or the feed
rate.
A precondition for this is a measurement of the internal consumption
and/or the feed rate.
Maximum plant output Enter the maximum output of your plant in the input eld.
Fig. 50: Conguration of the input signals of the MaxRemote
You have the possibility to congure the following parameters of the input signals of the
MaxRemote:
 Status
The MaxWeb XPN has 8 digital inputs (IN1 to IN8). Up to 256 input signal congura-
tions with the corresponding target capacities are therefore possible.
 Active
Mark the corresponding checkbox of the status which shall be active.
 IN1 ... IN8
If the checkbox is activated, the high-level signal is used on the selected input. If the
checkbox is deactivated, the low-level signal will be used.
 Effective power reduction -
Enter the effective power proportion in % of nominal power, to which the plant shall
be limited.
 Idle power
When the checkbox is selected, the plant will generate constant idle power. Enter
the value of the idle power in % of nominal power in the adjacent entry eld.
 cos(phi)
If this checkbox is selected, the PV plant generates idle power according to the eld
value and the current effective power. Enter the value for cos(phi) in the adjacent
entry eld.