Sony Ericsson GM47 - AT+CMER: Mobile Equipment Event Reporting

GM47/GM48 INTEGRATOR’S MANUAL
110
LZT 123 7263 R1A
3.25 AT+CMER Mobile Equipment Event Reporting
Enables or disables the sending of unsolicited result codes from ME to
TE in the case of key pressings, display changes, and indicator state
changes. <mode> controls the processing of unsolicited result codes
specified within this command. <bfr> controls the effect on buffered
codes when <mode> 1, 2 or 3 is entered. If the ME does not support
setting, +CME ERROR: <err> is returned.
<n> Description
0 Disable +CME ERROR: <err> result code and use ERROR
instead. Default value
1 Enable +CME ERROR: <err> result code and use numeric
<err> values (refer next subclause)
2 Enable +CME ERROR: <err> result code and use verbose
<err> values (refer next subclause)
Description Command Possible Responses
Set phone
activity status
AT+CMER=[<mode>
[,<keyp>[,<disp>
[,<ind>[,<bfr>]]]]]
•+CMEERROR:<err>
•OK
•ERROR
Read the
current setting
AT+CMER? •+CMER:
<mode>,<keyp>,<disp>,
<ind>,<bfr>
•OK
•ERROR
Test if the
command is
supported
AT+CMER=? • +CMER: (list of supported
<mode>s), (list of supported
<keyp>s), (list of supported
<disp>s), (list of supported
<ind>s), (list of supported
<bfr>s)
•OK
•ERROR
<mode> Description
0 Buffer unsolicited result codes in the TA; if TA result code
buffer is full, codes can be buffered in some other place
or the oldest ones can be discarded
1 Not Supported
2 Not Supported
3 Forward unsolicited result codes directly to the TE; TA-TE
link specific inband technique used to embed result
codes and data when TA is in on-line data mode
<keyp> Description
0 No keypad event reporting