Sony Ericsson GM47 - AT*ERIN: Ericsson Ring Set Configuration

GM47/GM48 INTEGRATOR’S MANUAL
140
LZT 123 7263 R1A
4.13 AT*ERIN Ericsson Ring Set
Used to set sound for incoming voice, line L1 and L2, fax, data calls and
alarm. For each of the incoming call types and alarm: voice on line 1,
voice on line 2, fax calls and data calls and alarm a sound type is
selected.
The type of sound is either a ring signal, selected from a predefined set,
a melody, selected from a predefined set, or an own melody, selected
from a set specified by the user.
Line 1 is the default for <call type> if the parameter is not given.
<place> Description
0 Hand held
1 Car mounted
Description Command Possible Responses
Sets ring type for
incoming voice (L1
and L2), fax and data
calls and alarm
AT*ERIN=
<sound type>,
[<call type>]
•+CMEERROR:<err>
•OK
•ERROR
Read the settings of
ring type and volume
for the call types
AT*ERIN? •*ERIN:<sound
type1>,<call type1>
[<CR><LF>…*ERIN:
<sound type
n>,<call type n>]
•+CMEERROR:<err>
•OK
•ERROR
Test if the command is
supported
AT*ERIN=? •*ERIN:listof
supported <sound
type>s, list of
supported <call
type>s
•+CMEERROR:<err>
•OK
•ERROR
<call type> Description
1 Line 1
2 Line 2
3 Fax
4 Data
5 Alarm